Get exclusive volume discounts, bulk pricing updates, and new product alerts delivered directly to your inbox.
By subscribing, you agree to our Terms of Service and Privacy Policy.
Direct access to our certified experts
WITH PELTIER COOLING MODE
CelCulture® Incubator: 240 L, IR Sensor, CO2 Control, 90°C Moist Heat Decon, Peltier System, UV Lamp, 100 VAC, 50/60 Hz
Temperature Control Method: Direct heat & Air Jacket using Microcontroller PI
Ambient Temperature Range*: 18 to 32°C (64.4 to 89.6°F)
Temperature Range, °C*: Ambient +5 to 60
Temperature Uniformity, °C*: < ±0.5
Temperature Accuracy, °C*: < ±0.1
Temperature Recovery Time**: (after 30 seconds door opening, 98% from initial value) ≤6 minutes
CO2 Control System: Microcontroller PI
CO2 Range, % CO2: 0-19.5
CO2 Accuracy, % CO2: ±0.1
CO2 Sensor: Infrared (IR) Sensor
CO2 Recovery Time****: (after 30 seconds door opening, 98% from initial value) Standard Unit: ≤6 minutes; Suppressed O2 model: ≤10 minutes
HUMIDITY
Humidification Method: Humidity pan
Humidity Range, %RH (at 37 °C)******: 85-90
PHYSICAL CONSTRUCTION
Interior Volume: 240 L
External Dimensions (W x D x H): 750 x 770 x 900 mm
Internal Dimensions (W x D x H): 595 x 640 x 633 mm
Chamber Construction
Main Body: Electrogalvanized steel with Isocide™ antimicrobial coating (except CCL-SS models with stainless steel exterior)
Interior Material: Stainless steel, type 304 (except CCL-Cu models with copper interior chamber)
Number of Shelves: 4
Maximum Number of Shelves: 7
Electrical Configuration
110-130 VAC, 50/60 Hz: Full Load Amps: 13.4 A
Electrical Configuration
220-240 VAC, 50/60 Hz: Full Load Amps: 6.5 A
Net Weight: 121 kg
CONTAMINATION CONTROL
Contamination Control Methods
1, Main body is electro-galvanized steel with Isocide™ antimicrobial coating;
2, 90˚C moist heat OVERNIGHT decontamination cycle (HPA validated);
3, ULPA filter********
4, 0.2-micron inlet filter for gas inputs;
5, 1-micron air circulation filter
6, UV lamp (for CCL-UV models only)
7, Copper chamber interior (for CCL-Cu models only)
All data recorded is specified for standard models with unloaded chambers and tested under optimum factory setting conditions of 23°C and 60% ambient humidity.
*Results are achieved when tested at 37°C as set point. Results may vary if set point changes and calibration is needed.
**For temperature not exceeding 37.2°C.
***Results are achieved when tested at 5% CO2 as set point. Results may vary if set point changes and calibration is needed.
****For CO2 level not exceeding 5.2%.
*****Results are achieved when tested at 5% O2 as set point. Results may vary if set point changes and calibration is needed.
****** For O2 level not lower than 4.8%.
*******Esco does not guarantee condensation-free chamber at humidity level higher than 90%.
********Not available for 50 L models.
